Die cutting manual paper waster stripper for Pneumatic Hand-held inner hole stripping tool round moulding

USER INSTRUCTIONS AND MAINTENANCE

1, Before / after each use, 3 drops of pneumatic tools need to be dropped from the air inlet special oil or diesel, just plug in the air pipe and press a few minutes. If the tool is used continuously for a long time, it is advised to drip once every 2 hours.

2, After connecting the air source, grasp the top with your plam and press down vertically to start working.

3, Always check whether the punching needles is tightly locked during use. Please lock it in time, if it is loosen.

4, When you don’t use it, please unplug the connector or turn off the air source in time.

5, If there is a malfunction, please stop using it and repair it in time.

HOW TO ORDER?