CHAOYI pneumatic paperbox waste strippers common FAQs

Q1:Does CHAOYI carton waste stripper work on all types of carton board?

Answer: Yes. Chaoyi cardboard waste stripping machine will also handle solid and corrugated fibre board.

Q2: Will I have to modify my dies?

Answer: This depends on how much stripping rules is already on the die. A waste strip of no more than 45 cm is ideal. The smaller the section, the easier it is to remove.

Q3: Will CHAOYI pneumatic paperbox waste stripper handle corrugated and laminated board?

Answer: Yes. Answer above applies. Also on how even a stack comes off the die-cutter. An uneven stack will not provide the support from below to allow the stripper to work efficiently removing the strip above.

Q4: Will CHAOYI paper waste diecut tool stripper handle large waste sections?

Answer: Yes. Provided that the cut is good and notching is not too heavy, large sections pose no problem.

Q5: Can I use the CHAOYI waste edge remover stripper on work coming off a hand platen?

Answer: This depends on a good even stack. It would be necessary to shutter up against a guide and also the ability to put stripping rule on the job in hand.

Q6: How much time will I save using the CHAOYI giftbox waste edge removing stripper?

Answer：A time saving of 85% is achievable against performing the task manually.

Q7: What is minimum waste strip depth the stripper is handle?

Answer: 5mm. You could follow below picture.